Belkin N+ PM00781EA F5D8635-4 - Manual (Page 34)

32
N+ Wireless Modem Router
sections table of contents 1 2 3 4 6 7 8 9 10 5
alTeRNaTe seTUP MeTHod
step 4: Configuring your Router for Connection to your Internet
service Provider (IsP)
The “Internet/WAN” tab is where you will set up your Router to connect
to your Internet Service Provider (ISP) . The Router is capable of
connecting to virtually any ISP’s system provided you have correctly
configured the Router’s settings for your ISP’s connection type . Your
ISP connection settings are provided to you by your ISP . To configure
the Router with the settings that your ISP gave you, click “Connection
Type” (a) on the left side of the screen . Select the connection type you
use . If your ISP gave you DNS settings, clicking “DNS” (b) allows you
to enter DNS address entries for ISPs that require specific settings .
Clicking “MAC Address” will let you clone your computer’s MAC address
or type in a specific WAN MAC address, if required by your ISP . When
you have finished making settings, the “Internet Status” indicator will
read “connection OK” if your Router is set up properly .
Connection Type
From the “Connection Type” page, you can select one of these five
connection types based on the instruction provided by your ISP:
• PPPoE
• PPPoA
• Dynamic/Fixed IP (1483 Bridged)
• Static IP (IPoA)
• Modem Only (Disable Internet Sharing)
Select the type of connection you use by clicking the radio button (1)
next to your connection type and then clicking “Next” (2) .
(a)
(b)
(1)
(2)