INFICON Q-pod Thin Film Deposition Monitor - Manual (Page 17)

1 - 5
IP
N 07
4-
54
7-
P1
B
Q-pod Operating Manual
Weight . . . . . . . . . . . . . . . . . . . . . . . 2 oz. (32 gm)
Computer Requirements . . . . . . . . . Any PC running Windows® XP / 2000 /
Windows 7 32-bit with one available USB
port for each Q-pod
1.5 Unpacking and Inspection
1 If the Q-pod has not been removed from its packaging, do so now.
2 Carefully examine the card for damage that may have occurred during
shipping. This is especially important if you notice obvious rough handling on
the outside of the container. Immediately report any damage to the carrier and
to INFICON.
3 Do not discard the packing materials until you have taken inventory and have
at least performed successful installation.
4 Take an inventory of your order by referring to your order invoice and the
information contained in
section 1.6.1 .
5 To install the Q-pod, see Chapter 2, Quick Start .
6 For additional information or technical assistance, contact INFICON, refer to
section 1.3 on page 1-4 .
1.6 Parts and Options Overview
1.6.1 Base Configuration
Q-pod Transducer w/Software . . . . . . . . .Q-POD
10 ft. USB Cable. . . . . . . . . . . . . . . . . . . .068-0472
6 in. BNC Cable . . . . . . . . . . . . . . . . . . . .755-257-G6
Technical Manual . . . . . . . . . . . . . . . . . . .074-547 on 074-5000-G1 CD
5.5 MHz Test Crystal . . . . . . . . . . . . . . . .782-902-023
1.6.2 Sensors
Front Load Single Sensor. . . . . . . . . . . . . . . . . . . . . SL-XXXXX
Cool Drawer Single Sensor . . . . . . . . . . . . . . . . . . . CDS-XXFXX
Sputtering Sensor. . . . . . . . . . . . . . . . . . . . . . . . . . . 750-618-G1
Front Load UHV Bakeable Sensor . . . . . . . . . . . . . . BK-AXF
NOTE: Multi-crystal (rotary) sensors & dual sensors should not be used with the
Q-pod.