Frc flux remover c aerosol – HMC Electronics MCC-FRC MicroCare Flux Remover C User Manual
Page 3
6
/
3
VERSION No. 3
FRC FLUX REMOVER C AEROSOL
7 HANDLING AND STORAGE
HANDLING
Provide good ventilation. Avoid inhalation of vapors/spray and contact with skin and eyes. Avoid contact with naked flames and hot
surfaces as corrosive and toxic decomposition products can be formed. Keep out of the reach of children.
STORAGE
Aerosol cans: Must not be exposed to direct sunlight or temperatures above 50°C.
8 EXPOSURE CONTROLS/PERSONAL PROTECTION
PROTECTIVE EQUIPMENT
ENGINEERING MEASURES
No specific ventilation requirements noted, except this product must not be used in a confined space without good ventilation.
RESPIRATORY EQUIPMENT
Considering the size of the packaging, the risk is regarded as minimal. Vapors are heavier than air and may travel along the floor and in
the bottom of containers. At work in confined or poorly ventilated spaces, respiratory protection with air supply must be used.
Self-contained breathing apparatus with full facepiece.
HAND PROTECTION
For prolonged or repeated skin contact use suitable protective gloves. Gloves of nitrile rubber, PVA or Viton are recommended.
EYE PROTECTION
Wear approved, tight fitting safety glasses where splashing is probable.
OTHER PROTECTION
Wear suitable protective clothing as protection against splashing or contamination.
HYGIENE MEASURES
No specific hygiene procedures noted, but good personal hygiene practices are always advisable, especially when working with
chemicals. When using do not eat, drink or smoke.
SKIN PROTECTION
Wear apron or protective clothing in case of splashes.
9 PHYSICAL AND CHEMICAL PROPERTIES
APPEARANCE
Clear liquid. Aerosol.
COLOR
Colourless.
ODOR
Slight odor. Ether
PHYSICAL DATA COMMENTS
Aerosol.
VOLATILITY DESCRIPTION
Volatile
SOLUBILITY
Slightly soluble in water.
BOILING POINT (°C)
37 C / 99 F
VAPOR DENSITY (air=1)
4.0
VAPOR PRESSURE
65 kPa 20 C / 77 F
VOLATILE BY VOL. (%)
100
SATURATION CONCENTRATION
(ppm)
600
10 STABILITY AND REACTIVITY
STABILITY
Stable under normal temperature conditions and recommended use.
CONDITIONS TO AVOID
Avoid contact with naked flames and hot surfaces as corrosive and toxic decomposition products can be formed.
HAZARDOUS POLYMERISATION
Will not polymerise.
Documentation Provided By HMC Electronics
33 Springdale Ave. Canton, MA 02021
(800) 482-4440