Frc flux remover c aerosol – HMC Electronics MCC-FRC MicroCare Flux Remover C User Manual
Page 2
6
/
2
VERSION No. 3
FRC FLUX REMOVER C AEROSOL
HFC-134a Tetrafluoroethane
212-377-0
811-97-2
10-30%
METHANOL
200-659-6
67-56-1
1-5%
PENTAFLUOROBUTANE
406-58-6
10-30%
trans-DICHLOROETHYLENE
205-860-2
156-60-5
10-30%
COMPOSITION COMMENTS
The Data Shown is in accordance with the latest EC Directives.
4 FIRST-AID MEASURES
GENERAL INFORMATION
NEVER MAKE AN UNCONSCIOUS PERSON VOMIT OR DRINK FLUIDS! Place unconscious person on the side in the recovery position
and ensure breathing can take place. Perform artificial respiration if breathing has stopped. Consult a physician for specific advice.
NOTES TO THE PHYSICIAN
No recommendation given, but first aid may still be required in case of accidental exposure, inhalation or ingestion of this chemical. If in
doubt, GET MEDICAL ATTENTION PROMPTLY!
INHALATION
Remove victim immediately from source of exposure. Move into fresh air and keep at rest. If respiratory problems, artificial
respiration/oxygen. Get medical attention.
INGESTION
Do not induce vomiting. If vomiting occurs, the head should be kept low so that stomach vomit doesn't enter the lungs. Do not give victim
anything to drink if he is unconscious. Promptly get affected person to drink large volumes of water to dilute the swallowed chemical. Get
medical attention.
SKIN CONTACT
Remove contaminated clothes and rinse skin thoroughly with water.
EYE CONTACT
Promptly wash eyes with plenty of water while lifting the eye lids. Make sure to remove any contact lenses from the eyes before rinsing.
Consult a physician for specific advice.
5 FIRE-FIGHTING MEASURES
EXTINGUISHING MEDIA
This product is not flammable. Use fire-extinguishing media appropriate for surrounding materials.
SPECIAL FIRE FIGHTING PROCEDURES
Move container from fire area if it can be done without risk.
UNUSUAL FIRE & EXPLOSION HAZARDS
Aerosol containers can explode when heated, due to excessive pressure build-up.
SPECIFIC HAZARDS
Avoid contact with naked flames and hot surfaces as corrosive and toxic decomposition products can be formed.
PROTECTIVE MEASURES IN FIRE
Self contained breathing apparatus and full protective clothing must be worn in case of fire.
FLAMMABILITY LIMIT -
LOWER(%)
7.5
FLAMMABILITY LIMIT - UPPER(%) 9.0
FLAMMABILITY CLASS
This product is not flammable.
6 ACCIDENTAL RELEASE MEASURES
PERSONAL PRECAUTIONS
Warn everybody of potential hazards and evacuate if necessary. Ventilate well, avoid breathing vapors. Use approved respirator if air
contamination is above accepted level.
ENVIRONMENTAL PRECAUTIONS
Contain spillages with sand, earth or any suitable adsorbent material. Avoid release to the environment.
SPILL CLEAN UP METHODS
Provide ventilation and confine spill. Do not allow runoff to sewer. Wear necessary protective equipment. Extinguish all ignition sources.
Avoid sparks, flames, heat and smoking. Ventilate. Collect with absorbent, non-combustible material into suitable containers.
Documentation Provided By HMC Electronics
33 Springdale Ave. Canton, MA 02021
(800) 482-4440