HMC Electronics MCC-DST MicroCare Dust Remover, MicroBlast User Manual
Page 3
7
/
3
Revision 7
DST - MICRO BLAST- BIG BLAST; HIGH PRESSURE PRECISION DUSTER
5.1. Extinguishing media
Extinguishing media
This product is not flammable. Use fire-extinguishing media appropriate for surrounding materials.
5.2. Special hazards arising from the substance or mixture
Hazardous combustion products
In case of fire, toxic gases (CO, CO2, NOx) may be formed.
Unusual Fire & Explosion Hazards
Aerosol containers can explode when heated, due to excessive pressure build-up.
Specific hazards
Avoid contact with naked flames and hot surfaces as corrosive and toxic decomposition products can be formed.
5.3. Advice for firefighters
Special Fire Fighting Procedures
Move container from fire area if it can be done without risk.
Protective equipment for fire-fighters
Self contained breathing apparatus and full protective clothing must be worn in case of fire.
SECTION 6: ACCIDENTAL RELEASE MEASURES
6.1. Personal precautions, protective equipment and emergency procedures
Aerosol containers can explode when heated, due to excessive pressure build-up. Warn everybody of potential hazards and evacuate if
necessary. Ventilate well, avoid breathing vapours. Use approved respirator if air contamination is above accepted level.
6.2. Environmental precautions
Contain spillages with sand, earth or any suitable adsorbent material.
6.3. Methods and material for containment and cleaning up
Wear necessary protective equipment. Extinguish all ignition sources. Avoid sparks, flames, heat and smoking. Ventilate.
6.4. Reference to other sections
See section 11 for more detailed information on health effects and symptoms.
SECTION 7: HANDLING AND STORAGE
7.1. Precautions for safe handling
Provide good ventilation. Avoid inhalation of vapours/spray and contact with skin and eyes. Avoid contact with naked flames and hot
surfaces as corrosive and toxic decomposition products can be formed. Keep out of the reach of children.
7.2. Conditions for safe storage, including any incompatibilities
Aerosol cans: Must not be exposed to direct sunlight or temperatures above 50°C.
7.3. Specific end use(s)
The identified uses for this product are detailed in Section 1.2.
SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION
8.1. Control parameters
8.2. Exposure controls
Protective equipment
Engineering measures
No specific ventilation requirements noted, except this product must not be used in a confined space without good ventilation.
Documentation Provided By HMC Electronics
33 Springdale Ave. Canton, MA 02021
(800) 482-4440