HMC Electronics MCC-DST MicroCare Dust Remover, MicroBlast User Manual
Page 2
7
/
2
Revision 7
DST - MICRO BLAST- BIG BLAST; HIGH PRESSURE PRECISION DUSTER
P210
Keep away from heat/sparks/open flames/hot surfaces. - No smoking.
P211
Do not spray on an open flame or other ignition source.
P251
Pressurized container: Do not pierce or burn, even after use.
P410+412
Protect from sunlight. Do not expose to temperatures exceeding 50 °C/122°
F.
P501
Dispose of contents/container in accordance with local regulations.
Supplemental label information
RCH002
Restricted to professional users.
RCH005a
This product is not to be used under conditions of poor ventilation.
2.3. Other hazards
This product does not contain any PBT or vPvB substances.
SECTION 3: COMPOSITION/INFORMATION ON INGREDIENTS
3.2. Mixtures
HFC-134a Tetrafluoroethane
90-100%
CAS-No.: 811-97-2
EC No.: 212-377-0
Classification (67/548/EEC)
Not classified.
Classification (EC 1272/2008)
Not classified.
The Full Text for all R-Phrases and Hazard Statements are Displayed in Section 16.
SECTION 4: FIRST AID MEASURES
4.1. Description of first aid measures
General information
NEVER MAKE AN UNCONSCIOUS PERSON VOMIT OR DRINK FLUIDS! Place unconscious person on the side in the recovery position
and ensure breathing can take place. Perform artificial respiration if breathing has stopped. Keep out of the reach of children.
Inhalation
Move into fresh air and keep at rest. If respiratory problems, artificial respiration/oxygen.
Ingestion
DO NOT INDUCE VOMITING! Immediately rinse mouth and drink plenty of water (200-300 ml). Consult a physician for specific advice.
Skin contact
Remove contaminated clothes and rinse skin thoroughly with water.
Eye contact
Promptly wash eyes with plenty of water while lifting the eye lids. Make sure to remove any contact lenses from the eyes before rinsing.
Consult a physician for specific advice.
4.2. Most important symptoms and effects, both acute and delayed
General information
The severity of the symptoms described will vary dependant of the concentration and the length of exposure.
Inhalation.
Vapours may cause headache, fatigue, dizziness and nausea. Difficulty in breathing.
Ingestion
Due to the physical nature of this material it is unlikely that swallowing will occur.
Skin contact
No specific symptoms noted.
Eye contact
Prolonged contact may cause redness and/or tearing.
4.3. Indication of any immediate medical attention and special treatment needed
No recommendation given, but first aid may still be required in case of accidental exposure, inhalation or ingestion of this chemical. If in
doubt, GET MEDICAL ATTENTION PROMPTLY!
SECTION 5: FIREFIGHTING MEASURES
Documentation Provided By HMC Electronics
33 Springdale Ave. Canton, MA 02021
(800) 482-4440