Barco R9001390 - Manual (Page 48)

Service Mode
10-2 5975938 BARCOREALITY 9200TCR+ 020798
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
CHANGE BAUDRATE PC
RESET LAMP RUNTIME
LAMP RUNTINE HISTORY
LAMP DRIVE MODE
MORE...
Select with or
then
to return.
SERVICE
BARCO LOGO
PANEL ADJUSTMENTS
PRESET INPUT BALANCE
I2C DIAGNOSIS
MORE...
Select with or
then
to return.
BARCO LOGO
STATUS :
BACKGROUND :
SHIFT
HOT KEY :
Select with or
to toggle/select
to return.
I2C DIAGNOSIS
D CA
LCD DRIVER SC76013 E4H # # #
LCD DRIVER SC76013 E6H # # #
LCD DRIVER SC76013 E8H # # #
LCD DRIVER SC76013 EAH # # #
INPUT SELECT TDA8444 46H # # #
INPUT SELECT PCF8574A 7EH # # #
DECODER 87C751 12H # # #
LAMP DRIVER PCF8574A 72H # # #
POWER SUPPLY 87C752 10H # # #
PANEL ADJUSTMENT
Select the
color temperature
PROJECTOR WHITE
6500
Select with or
then
to return.
PRESET INPUT BALANCE
WHITE BALANCE
BLACK BALANCE
DEFAULT
Select with
to return
Adjust
red with or
blue with or
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
CHANGE BAUDRATE PC
RESET LAMP RUNTIME
LAMP RUNTINE HISTORY
LAMP DRIVE MODE
MORE...
Select with or
then
to return.
- software version
- Proj. Address : to change the address of the projector, see Change
Projector Address in this chapter.
- Installation : possible installations :
* Front/Ceiling
* Front/Table
* Rear/Ceiling
* Rear/Table
To change the installation configuration follow the instructions in
chapter Installation Set Up.
- Baud rate : transfer speed for communication with an IBM PC (or
compatible) or MAC. The baud rate of the projector must be the same
as the baud rate of the connected computer. When there is a
difference, consult 'Change Baudrate PC' in this chapter.
- Projector Run Time : gives the total run time since the first start up.
All projectors leave the factory with a run time of approximately 24
hours.
- Projector Serial number : indicates the fabrication number of the
projector. This number can be useful when calling for technical
assistance.
Identification
To display the Identification screen, push the control disc up or down
to highlight Identification and press ENTER to display the Identifica-
tion screen.
The Identification screen gives an overview of :
- type of projector
- projector address
- software version
- installation configuration
- baud rate
- text ON
- projector serial number
- projector run time
- type of projector : BARCOREALITY 9200 TCR P LUS