ElmoMC Gold Line Digital Servo Drives-Gold Bell - Manual (Page 23)

Gold Bell Installation Guide
MAN-G-BELIG (Ver. 1.004)
www.elmomc.com
23
Chapter 4: Installation
The Gold Bell must be installed in a suitable environment and properly connected to its voltage
supplies and the motor.
4.1. Site Requirements
You can guarantee the safe operation of the Gold Bell by ensuring that it is installed in an
appropriate environment.
Feature Value
Ambient operating temperature 0 °C to 40 °C (32 °F to 104 °F)
Maximum non-condensing humidity 90%
Operating area atmosphere No flammable gases or vapors permitted in area
Models for extended environmental conditions are available.
Caution:
The Gold Bell dissipates its heat by convection. The maximum ambient
operating temperature of 40 °C (104 °F) must not be exceeded.
4.2. Unpacking the Drive Components
Before you begin working with the Gold Bell, verify that you have all of its components, as
follows:
• The Gold Bell servo drive
• The Elmo Application Studio (EAS) software and software manual
The Gold Bell is shipped in a cardboard box with Styrofoam protection.
To unpack the Gold Bell:
1. Carefully remove the servo drive from the box and the Styrofoam.
2. Check the drive to ensure that there is no visible damage to the instrument. If any damage
has occurred, report it immediately to the carrier that delivered your drive.
3. To ensure that the Gold Bell you have unpacked is the appropriate type for your
requirements, locate the part number sticker on the side of the Gold Bell. It looks like this: