Eberspacher EasyStart Call - Manual (Page 4)

4 | VehiCLe heATeRs – TeChniCAL DOCuMenTATiOn
ƒ The heating duration or ventilation duration
in immediate operation is factory set to 30
minutes for a water heater and to continu-
ous operation for an air heater.
ƒ The heating duration or ventilating duration
can be changed and saved. A time period
from 10 to 120 minutes can be selected.
ƒ Continuous operation is only available for
air heaters in immediate operation.
ƒ Continuous operation is not possible when
the timer function is used.
ƒ if the heater is switched on, the indicator
light on the button illuminates.
ƒ if there is a fault on the easystart Call or
the heater and the “heater error message”
function is configured, then an sMs
message is sent to the control unit (mobile
phone / fixed line telephone).
ƒ After operating mode ventilation has
finished, factory setting heating is
re-activated.
ƒ To request the interior temperature,
the room temperature sensor must be
connected.
The room temperature sensor is included in
the scope of supply.
ƒ it is only possible to change the set
temperature with an air heater.
ƒ if the easystart Call is called in a foreign
country, additional costs are charged
(roaming charges).
ƒ if the easystart Call is called in the border
area with a neighbouring country, roaming
charges can also be incurred due to
overlapping network coverage.
ƒ note the location of your vehicle with
respect to the call setup.
ƒ if this easystart Call cannot connect to a
gsM network (e.g., the customer parks for
a longer period of time in an underground
car park) the easystart Call attempts to
connect to the gsM network at continu-
ously increasing intervals until a connection
setup is successful.
ƒ Recommendation: When you press the
button, a connection setup is started;
duration approx. 3 min.
ƒ To prevent excessive discharge of the
vehicle battery in preselected heating
mode, we recommend you set the heating
duration according to the trip time.
example:
For a trip time of approx. 30 minutes
(single distance), the heating period should
be set to 30 minutes.
PlEasE NotE!
The ventilation function is not supported for
all heater designs.
please note the Technical Description for the
heater.
1 inTRODuCTiOn