Eberspacher EasyStart Call - Manual (Page 29)

Vehicle heaters – Technical Documentation | 29
3 DispLAys AnD MALFunCTiOns
malfunction
heater error feedback
cause of error
ƒ remedial action
Fault in data communication between
easystart Call and heater.
erD:heaterCom:lost,heater:off
erD:heaterCom:lost
Auxiliary heater configured as parking heater.
ƒ Try to start again.
ƒ Check installation and configuration.
ƒ Contact your Je service partner.
erD:heaterCom:no_heater_found heater was not recognised during initial opera-
tion (heater cannot be switched on):
ƒ Try starting again.
ƒ Remove and then re-insert the fuse.
ƒ Run through initial operation again.
ƒ Contact your Je service partner
erL:DatCom:lost error in the wiring.
ƒ Contact your Je service partner
erh:heater:mode_not_supported incorrect entry.
ƒ The requested function is not supported by
the heater.
ƒ Repeat entry.
Fault heater.
erh:heater:error
Fault on the heater.
ƒ Try to start again.
ƒ Contact your Je service partner.
no temperature display.
erC:Temp:missing
Temperature sensor not installed.
no temperature display although tempera-
ture sensor installed.
erC:Temp:short_circuit
Temperature sensor defective.
ƒ Contact your Je service partner.
Time and day of week in the easystart Call
are invalid.
erC:DeviceTime:time_not_set
The provider does not support the function
“Automatic time”.
ƒ Manually set the day of the week and the
time.