Det-Tronics ATX10 Transmitter - Manual (Page 12)

2.5 95-8657 10
Figure 5—procedure for Removal and Re-installation of
SD memory Card
SLIDE THE LOCKING CONNECTOR BACK APPROXIMATELY
1/8 INCH (3 MM) TO UNLOCK THE SD CARD.
WHEN UNLOCKED, THE CARD/CONNECTOR ASSEMBLY
AUTOMATICALLY OPENS TO THIS POSITION.
MOVE THE CARD/CONNECTOR ASSEMBLY TO THIS “FULL OPEN”
POSITION. BEFORE REMOVING THE CARD, NOTE ITS POSITION.
THE CARD MUST BE RETURNED TO THIS EXACT POSITION LATER
IN ORDER TO CLOSE THE CONNECTOR.
REMOVE THE SD CARD. WITH THE CARD REMOVED, THE
CONNECTOR LIES FLAT AGAINST THE CIRCUIT BOARD.
TO RETURN THE SD CARD, PLACE THE CARD IN THE CONNECTOR
AS SHOWN. NOTE ITS POSITION AGAINST THE TAB. REPEAT THE
FIRST THREE STEPS IN REVERSE ORDER AS FOLLOWS:
RAISE THE CARD/CONNECTOR ASSEMBLY WHILE GENTLY
PRESSING THE CARD AGAINST THE TAB. WHEN THE CARD
CLEARS THE TAB (SEE PHOTO #3), THE CONNECTOR CAN BE
CLOSED AND LOCKED.
STEP #1
STEP #2
STEP #3
STEP #4
STEP #5
TAB
UNLOCK