Despatch Protocol Controller User Manual

Page 40

C The profile number is manually entered using the + or - keys.

C Six segments exist for each profile.

C If the ramp time and soak time for any one segment is zero, Protocol ignores the

remaining segments.

C The REPEAT TIMES command is the number of times to execute the profile being

programmed.

C The HOLD command is contingent on the final segment of the last profile to be run

only.

C A soak time will not begin until the actual temperature is within the soak-deviation

limit. (Assured soak limit).

C Make sure the proper starting profile number is displayed in the PRO- prompt before

executing the profile to be run.

While a program is being executed, pressing the Reset key will display the profile
number, segment number and the number of loops (REPEAT TIMES) remaining.
Pressing the Start key will display the appropriate ramp or soak time remaining (TR.)

If Protocol is in a HOLD condition, pressing the Reset key will display that the control is
in segment 7 (HOLD.)