Despatch Protocol Controller - Manual (Page 19)

13
NOTE: When the Timer mode is
running, pressing the Start key will
display the time remaining in the
cycle. The display will show
TRHHMMSS which stands for the
time remaining, hours, minutes
and seconds.
b. Use the + or - keys to select either YES or NO.
C
Press the - key to display NO and begin timing at ambient.
C
Press the + key to display YES and begin timing at the following
input temperature.
c. Press the – key. TEMP and the begin timing temperature will be
displayed.
d. If YES was selected in step b, use the + or - keys to enter the temperature
at which the process timer begins timing.
If NO was selected in step b, this setpoint has no bearing on oven
operation.
Run
The following are run instructions for the Timer mode.
1. Press the – key. READY will be displayed.
2. Press the Heater on key. The Heater Relay
LED will illuminate.
3. Press the Start key. The Heater on LED will
illuminate and the setpoint and the actual
temperature will be displayed. As the oven
temperature approaches the setpoint, the
Heater on LED will cycle on and off.
Manually Stop
The following are manual stop instructions for the Timer mode.
1. Press the Heater off key.
2. Wait for oven temperature to fall below 100
E C (212E F).
3. When the Timer mode is complete, press the Reset key to display the final
process temperatures.
4. Press the Stop key.