Dakota Ultrasonics DFX-7 plus MANUAL1 User Manual

Page 26

Dakota Ultrasonics

Note: Above will trigger the alarm when a signal meets or exceeds the height

of the gate, and below will detect on anything that meets or is below the height

of the gate.

3) Alternatively, press the ENTER key to display the Digits Edit Box.

4) Press the UP and DOWN arrow keys to scroll the highlighted value.

5) Press the LEFT and RIGHT arrow keys to scroll the digit locations.

6) Repeat steps 4 & 5 until the start position is correctly displayed.

7) Press the OK key to set the WIDTH1 position and return to the menu

screen, or ESC to cancel entering the WIDTH1 position.

Note: This procedure is universal for all the features in the Hot Menu cell

locations.

3.27 Top & Bottom End Caps

The top & bottom end panels are where all connections are made to the DFX-7. The
diagram above shows the layout and description of the connectors:

Transducer Connectors

Refer to Diagram: The transducer connectors, and battery cover/probe zero disk are
located on the DFX-7’s top end cap. The transducer connectors are of type LEMO
“00”. A single element transducer must be plugged into the inside LEMO jack as
illustrated above. Note: There is no polarity associated with connecting a dual
element transducer to the DFX-7.

This manual is related to the following products:

DFX-7 MANUAL1