Dakota Ultrasonics DFX-7 plus MANUAL1 - Manual (Page 146)

Dakota Ultrasonics
142
5) When the Setup Name is highlighted, press the ENTER key to display the
confirmation screen.
6) Press the OK key to delete the Setup File.
7) Finally, press the MEAS key to return to the measurement screen.
13.5 Using the Default Setup
The default setup feature was added to the DFX-7 to use, as a last resort, if there are
no setups stored in the gauge –factory or otherwise. The only time this might
possibly occur is if the setup file in the DFX-7 was somehow corrupted, and the user
does not have access to a computer to re-load the factory setups back into the DFX-
7. This gives the user the ability to load and modify a basic setup as follows:
Note: The default file contains no probe zero data. Therefore, a zero must be
performed after loading. Also, the default setup can be loaded when using the flaw
mode feature, to eliminate the probe zero delay value, and start at the initial pulse or
zero.