Dakota Ultrasonics CMX DL - Manual (Page 44)

Dakota Ultrasonics
40
In this first example the transducer was automatically identified:
Probe Automatically Recognized
1) Press the OK key once to use the identified probe, or ESC to display a list of
optional transducers. Note: if the CMX
DL
recognizes a specific transducer,
the user should always select OK to use the identified probe. The only time
an alternative probe should be selected from a list is if the user switched
probes following initial power up and recognition, or the CMX
DL
has
somehow identified the probe in error..
2) Assuming the CMX
DL
recognized the probe and the OK key was pressed,
the CMX
DL
will advance to a Zero Probe menu. If the transducer was
identified as a special transducer capable of measuring coating thickness, a
menu will be displayed allowing the user the ability to toggle the coating
thickness display on/off as follows: