Brother HL-3260N - Manual (Page 269)

APPENDICES
Appendix–27
"
Bar Code, Expanded Character, Line Block Drawing & Box Drawing Offset in
X-axis
n = “xnnn” or “Xnnn”
This parameter specifies the offset from the left margin in the “u”- or “U”-
specified unit.
"
Bar Code & Expanded Character Offset in Y-axis
n = “ynnn” or “Ynnn”
This parameter specifies the downward offset from the current print position
in the “u”- or “U”-specified unit.
"
Bar Code, Expanded Character, Line Block Drawing & Box Drawing Height
n = “hnnn”, “Hnnn”, “dnnn”, or “Dnnn”
(1) EAN13, EAN8, UPC-A, ISBN (EAN13, EAN8, UPC-A),
ISBN (UPC-E): 22 mm
(2) UPC-E: 18 mm
(3) Others: 12 mm
Expanded characters
➞ 2.2 mm (default)
Line Block Drawing & Box Drawing
➞
1 dot
This parameter specifies the height of bar codes or expanded characters as
above. It can take the prefix “h”, “H”, “d”, or “D”. The height of bar codes is
specified in the “u”- or “U”-specified unit. Note that the default setting of the
bar code height (12 mm, 18 mm or 22 mm) is subject to the bar code mode
selected by “t” or “T”.
"
Expanded Character Width, Line Block Drawing & Box Drawing
n = “wnnn” or “Wnnn”
Expanded character
➞
1.2 mm
Line Block Drawing & Box Drawing
➞
1 dot
This parameter specifies the width of expanded characters as above.