COATS Kit 85606689 Leverless Bead Lifter - Manual (Page 8)

8 • Important: Always read and follow the instructions.
Leverless Bead Lifter
Operation
This accessory is normally used in the servicing of
single piece automotive and most light truck tire/wheel
assemblies.
Demounting
Follow tire changer operating instructions provided
for demounting a standard wheel assembly, except:
1. After deflating and bead loosening, clamp the
wheel to the table top. Position leverless arm until
mount/demount head plastic contacts wheel.
3. Tighten swing arm adjustment screw until it con-
tacts arm.
4. Lube leverless tool.
Note: To aid bead lubing, lower leverless tool slightly
to move bead away from wheel.
5. Position valve stem approximately as shown to
prevent damage to TPMS (Tire Pressure Monitoring
System) sensor.
6. Push control handle down to lower leverless tool
under tire bead while pulling leverless handle to hold
leverless bead lifter against the wheel.
Note: If leverless tool does not hook under tire bead,
reverse rotation. Re-position valve stem while pushing
bead opposite leverless bead lifter into drop center.
7. Push control handle up, retracting leverless tool.
Note: Use helper arms if equipped.
8. Rotate tire to remove top bead.
9. Position valve stem as shown in step 5.
10. Repeat #6
11. While holding tire up into drop center, lift tire to
hook the bead on leverless tool, push control handle up
to lift bead over rim.
12. Rotate to remove tire.