COATS 1250 Series Balancer - Manual (Page 14)

8 • Important: Always read and follow the information box instructions.
(See Figure 14A or 14B)
1 Weight Display Windows
2 Mode Indicators
3 Left Weight Position Bars
4 Right Weight Position Bars
5 Direct Select™ & Wheel Cross-section Diagram
6 Information Box
7 Balancer Options
8 Keypad Group
9 Instructional Panel
Control Panel Function and Review
If you select/press …
a Direct Select Weight key (Clip 1,
T1-Tape, Patch Static, T2-Tape, T3-
Tape, or Clip 2)
the T2-Tape key
the Dynamic/Static key(s)
the Behind Spoke key
the Spoke 1/Spoke 2 key
a Wheel Dimension key (A, D, or
W)
the Next key
the Stop & Exit key
hold Shift and press 1
hold Shift and press 3
hold Shift and press 4
hold Shift and press 5
hold Shift and press 6
hold Shift and press 7
hold Shift and press 8
hold Shift and press 9
Then …
on the Wheel Cross-section diagram, the activated weight location illumi-
nates.
the laser indicator illuminates; Laser Guided Operation™ mode activates.
additional balance modes may be accessed. For additional information,
see Balance Options, page 11.
the indicator illuminates showing the mode is on.
the indicator illuminates showing the activated spoke location.
enter wheel data manually using the “ numbered” keys.
additional functions or instructions may be accessed, such as moving to
the next weight location.
a measurement cycle or function is ended. Also used to toggle the invert-
er off for manual wheel positioning.
the Calibrate Machine mode is activated.
the Arm Calibrate mode is activated.
either 0.25-ounce Standard roundoff or 0.50-ounce RV-Lite Truck (RV
mode indicator illuminates) is toggled on.
the Match Balance indicator illuminates showing the mode is on.
either the 0.25-ounce or 0.01-ounce weight increment is toggled on.
either the Operator A or the Operator B mode illuminates to indicate the
active operator memory.
Hood Start is turned On or Off.
either ounce or gram weight measurements is toggled on.