CiDRA GVF-100 Gas Volume Fraction Monitoring System - Manual (Page 93)

Copyright © 2006 CiDRA Corporation Page 11-4
20639-01 Rev 03
the Line 4 value press ‘ENTER’ and use the arrow keys to enter
the new value. Note: if an external pressure transducer that reads
pressure in ‘absolute’ values (e.g. PSIa, BARa, or KPaa is used an
altitude correction is not necessary.
•
Press the ↓ key to scroll to ‘→Set Date/Time’ on Line 2. Press the
‘ENTER’ key and the current saved date and time will be displayed
on Line 4 of the display. Use the arrow keys (
↑ and ↓ to scroll
through the values and ← and → to change character) to enter the
date and time. If possible, synchronize the date and time entered
to that of the process control data system. Note: Time is in 24-
hour format. Once the date and time have been set press the
‘ENTER’ key followed by the ‘BACK’ key.
•
At this point ‘Basic Config’ is displayed on Line 1 of the display.
The user can re-enter this menu if desired by pressing the
‘ENTER’ key or by pressing the
↑ or ↓ arrows to move to other
Level 1 menus (see Table 12).
Entry of inputs to the other Level 1 menus is by the same process as
used in ‘Basic Config’.
The following table provides a template for recording the transmitter
setup for future reference.