CiDRA GVF-100 Gas Volume Fraction Monitoring System - Manual (Page 89)

Copyright © 2006 CiDRA Corporation Page 10-15
20639-01 Rev 03
10.3 Resetting to Factory Defaults
Note: It is recommended that factory defaults be reset only by factory
qualified service personnel. All factors (Basic Config, Output Config,
etc.) must be re-entered following a Reset to Factory Defaults.
To ‘Reset to Factory Defaults’, press and hold the ‘EXIT’ key while
pressing the reset switch on the upper left edge of the connector block
board.
Alternatively, switch transmitter Power OFF and press and hold the
‘EXIT’ key while turning Power On. Hold the ‘EXIT’ key until the
screen prompt is shown. If you decide you do not want to reset
factory defaults, either cycle power or press any key other than
‘ENTER’.