chiliGREEN 17 M670SU MK2 User Manual
Page 135
Troubleshooting
Problems and Possible Solutions 8 - 9
8
Nothing appears on
screen.
The system is in a power saving mode. Toggle the sleep/resume key combination, Fn + F4 (see
“Configuring the Power Buttons” on page 3 - 8
The screen controls need to be adjusted. Toggle the screen control key combinations Fn + F8/F9.
If you’re connected to an external monitor, make sure it’s plugged in and turned on. You should
also check the monitor’s own brightness and contrast controls.
The computer is set for a different display. Toggle the screen display key combination, Fn + F7. If
an external monitor is connected, turn it on.
The screen saver is activated. Press any key or touch the TouchPad.
No image appears on
the external monitor I
have plugged in and
powered on.
You haven’t installed the video driver and configured it appropriately from the Control Panel. See
“Video Features” on page E - 10
for instructions on installing and configuring the
video driver.
You forget the boot
password.
If you forget the password, you may have to discharge the battery of the CMOS. Contact your
service representative for help.
Problem
Possible Cause - Solution
Password Warning
If you choose to set a boot password, NEVER forget your password. The consequences of this could be serious. If you cannot
remember your boot password you must contact your vendor and you may lose all of the information on your hard disk.