CHAMPION EUCC Series - Manual (Page 26)

18
Troubleshooting
Troubleshooting
On occasion your machine may not operate as expected.
Use the checklist below before you decide that a mechanical or electrical failure has occurred.
Checklist
1. are the main disconnect switches, breakers, or motor overloads turned ON?
2. are the main water and steam supplies turned ON?
3. are the drain valves closed?
4. are the spray pipes and rinse nozzles clean?
5. are the spray pipes in the proper locations?
6. are the pump intakes clean?
7. are the scrap screens clean and in place?
8. are the thermostats correctly adjusted?
9. are the high limit temperature thermostats reset?
10. are the doors fully closed?
11. are the conveyor shut-off and drive assemblies in operating condition?
12. are the chemical supplies adequately filled?
If a problem still exists after verifying the checklist, refer to the following
CONDITION CAUSE SOLUTION
Conveyor will not run Door not closed ................................... Make sure doors are fully closed
Door safety switch faulty .................... Contact your service agency
Start switch faulty ............................... Contact your service agency
Main switch OFF ................................ Check disconnect
Control panel power switch OFF ........ Flip switch ON
Conveyor shut-off shelf operated........ Move shelf toward tunnel of machine
Motor overload protector tripped ........ Reset overload in control cabinet
Green start button not pressed ............ Press green start button