Online manual not for resale purposes – BLITZ Toyota Celica Compressor System User Manual

Page 32

(C.58) Switch box

for the
clutch

(C.59) Relay box.

Tighten
together

with

this nut.

6mm round
terminal.
Location for the

Ground (brown wire)

Ignition ON (power supply)

Computer terminal arrangement figure

WARNING: All images and text in this manual is the property of Blitz Co., Ltd. (Japan). No parts of this manual may be
reproduced, stored in retrieval systems, or transmitted in any way without prior written permission of Blitz Co., Ltd. (Japan)

Make a hole here

(C.47) φ4 hose

(C.57)

ressure

Connect the

(33) (C.57) Installation of the pressure sensor

①

Fix the (C.57) pressure sensor using the
(C.65) lock tight at the location shown in the
figure.

②

Install the (C.47) φ 4 hose that was
installed to the (C.39) nippleφ4-1/8PT at
the (C.2) intake manifold to the (C.57)
pressure sensor and use the (C.65) lock
tight to tighten it.

※

Cut the (C.47) φ4hose to an adequate

length.

③

Pass through the lid of the (C.63) computer
box by making a hole as shown in the figure.

④

Connect the (C.63) access computer’s
connector with the (C.57) pressure sensor’s
connector.

⑤

Install the lid of the computer box.

(34)Fix in place the (C.46) φ6 tube, (C.47) φ4

hose, (C.58) wiring for the clutch switch and
the (C.59) wiring for the relay harness using
the (C.65) lock tight so it does not get in
contact with moving or highly heated
components.

Online Manual Not For Resale Purposes