Online manual not for resale purposes – BLITZ Toyota Celica Compressor System User Manual

Page 17

WARNING: All images and text in this manual is the property of Blitz Co., Ltd. (Japan). No parts of this manual may be
reproduced, stored in retrieval systems, or transmitted in any way without prior written permission of Blitz Co., Ltd. (Japan).

ｂ．ボルト

(C. n) Stud

(C. 23) Pipe No. 1

(C. 24)
Pipe No. 2

(C. 44)

19 hose

(C. 51)

(7) Installation of the blow by hose.

①

Install the (C. 23) blow by pipe No. 1, and
(C. 24) blow by pipe No. 2 by reusing
the genuine gasket and nuts.
※

Appling torque.

＝１０Ｎ・ｍ（１００ｋｇｆ・ｃｍ）

②

Cut the supplied hose (C. 44) to
approximately 300mm to connect the
ends of the blow by pipe No.1 and No.2,
and tighten the ends with the supplied
(C. 51) clamp.

(6) Installation of (C. 2) Intake manifold.

①

Remove the long stud bolt (one bolt) at the right
end from the two genuine stud bolts.

②

Install the (C. n) stud bolt M8 (2P).

③

Remove one genuine nipple from the genuine
intake manifold.

④

Install the genuine nipple removed from step
③

, the (C. 41) nipple ) nippleφ21-3/4 PT, the

(C. 40) nipple φ 6-1/8 PT and the (C. 39)
nipple φ 4-1/8 PT to the supplied intake
manifold.

Genuine Nipple

※

Use a seal tape or a sealant to install the
nipple and the sink plug.

⑤

Install the (C. 2) intake manifold by using two
sets of genuine intake manifold bolts and nuts,
and one (C. p) M8 flange nut.
※

Appling torque.

＝３４Ｎ・ｍ（３５０ｋｇｆ・ｃｍ）

Clamp

Genuine Nipple

(C. 41) Nipple

(C. 39) Nipple

(C. 40) Nipple

Genuine bolts and nuts

(C. p) Nut

Online Manual Not For Resale Purposes