Online manual not for resale purposes – BLITZ Toyota Celica Compressor System User Manual

Page 24

WARNING: All images and text in this manual is the property of Blitz Co., Ltd. (Japan). No parts of this manual may be
reproduced, stored in retrieval systems, or transmitted in any way without prior written permission of Blitz Co., Ltd. (Japan).

（

22）relocation of the air bag sensor

(C.16) Air bag

sensor stay

Genuine bolt

(C.e) Bolt

(C.p) Nut

Air ba

g sensor

①

Remove the sensor located at the left
side of the vehicle by removing two
bolts.

②

Install back using the (C. 16) air bag
sensor stay (2P), (C. e) flange bolt
M8X16 (2P), (C. p) flange nut M8 (2P)
and the genuine bolts (2P).

※

Appling torque.

＝２５Ｎ・ｍ（２５０ｋｇｆ・ｃｍ）

※

Cut the tape bundling the sensor’s

wire to give some slack to the wire.

（

23）Installation of the (C. 11) Idle Pulley.

①

Install the (C. 6) idle pulley bracket to
the (C. 4) oil pan using the (C.m) cap
bolt M8 X 15 (3P).

(C.m) Bolt

(C.4) Oil pan

(C.6) Idle

pulley

bracket

(C.11) Location to

install the idle pulley

(C.m) Bolt

※

Appling torque.

＝１８．５Ｎ・ｍ（１８８ｋｇｆ・ｃｍ）

②

(C. 9) Idle pulley collar (2P).
Install the (C. 11) idle pulley (2P) using
the (C.i) flange bolts M10 X 35 (2P).
※

Appling torque.

(C.i)

＝４５Ｎ・ｍ（４５０ｋｇｆ・ｃｍ）

※

The (C. 11) idle pulley’s flange must be

installed towards the (C.9) collar.

(C.11) Idle pulley

（

24）Install the (C. 53) V belt by loosening the

tension pulley. (See the figure below)

(C.1) Compressor

TensionPulle

A/C

Crank shaft

Alternator

Stee

ring

Wate

Power

(C. 53) V belt

(C. 12) Idle

Pulley

(C. g) Bolt

(

C. 12) Idle

Pulley

(C. 9)

Collar

The flange goes

towards the Collar

(C. 6)

Online Manual Not For Resale Purposes