Online manual not for resale purposes – BLITZ Toyota Celica Compressor System User Manual

Page 29

⑥

Make cutting alteration to the front bumper where the intercooler and the pipes get
into contact.

※

Make sure to wear protective clothing and safety glasses while working on the

vehicle.

⑦

Reconnect the connectors to the front bumper.

※

Tighten together the front bumper and the (C.18) intercooler stay A using the (C.c)
flange bolt M6X20 and (C.r) washer M6 at the location shown in figure 6.

※

The energy absorber, re-enforcement and the fog lamp can not be installed.

⑧

Install back the engine cover the way it was.

WARNING: All images and text in this manual is the property of Blitz Co., Ltd. (Japan). No parts of this manual may be
reproduced, stored in retrieval systems, or transmitted in any way without prior written permission of Blitz Co., Ltd. (Japan)

(C.27)Pipe No.2

(C.29)Pipe No.4

Install the

stay h

Bend this pipe so that it
does not get into contact
with the (C.30) intake pipe

No. 6.

Fig1

(C.30) Pipe No.6

(C.26) Pipe No.1

Throttle body

Outlet

chamber

Fig2

(C.30)Pipe No.6

(C.31)Elbow pipeφ60

(C.29)Pipe No.4

(C.33)siliconeφ60

Fig3

(C.28)Pipe No.3

(C.25) Intercooler

(C.29)Pipe No.4

Install the

stay

here

Fig5

図２

Fig4

Fig6

(C.c) Bolt
Tighten

together.

Front bumper

(C.18)Stay A

Online Manual Not For Resale Purposes