BAND-IT SM1700 Pneumatic Center Punch Tool - Manual (Page 4)

Document# SM1750 Rev. E
© Copyright
BAND-IT-IDEX, Inc. 2012
All rights reserved
www.BAND-IT-IDEX.com
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street Denver, CO 80216-3070 USA
P: 1-800-525-0758 F: 1-800-624-3925
4
SM1700
Pneumatic
Center Punch
Tool
Important: For proper tool performance, follow air requirements for SM1700:
Line Pressure – 70 psi minimum,120 psi maximum (4.9 – 8.4 kg/cm^2, 483 – 827 kPa).
Volume - 3-5 CFM
Air Delivery system - ¼” minimum diameter air line with a ¼” N.P.T. connection.
Filtration – Follow typical filtration requirements of air operated equipment. The BAND-IT
supplied system includes a filter and lubricator.
Lubrication - Use DTE 24 hydraulic oil (BAND-IT part # S31589), oil drip-rate is verified by
cycling the machine. If one drop falls in sight glass within 10-25 cycles, the lubricator is
correctly adjusted. Excess oil will not benefit tool life and may lead to blockage of air
mufflers and a dirty environment.
Solvents - Liquids such as solvents or cleaners should never be added to the air system
through air lines.
View of the back side of the SM1700 showing the supplemental
(included) filtering and lubrication system as well as the ¼” N.P.T.
air connection with a typical quick connect coupling.
Air System
Requirements
Air connection
Oil drip rate
adjustment knob
Oil fill location
Caution!
Disconnect air
supply before
removing plug.
Warning: The lubricator should be refilled with DTE 24 hydraulic
oil only. The use of other oils may cause damage to the system.