Factory services – BAND-IT SM1700 Pneumatic Center Punch Tool User Manual
Page 18
Document# SM1750 Rev. E
© Copyright
BAND-IT-IDEX, Inc. 2012
All rights reserved
www.BAND-IT-IDEX.com
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street Denver, CO 80216-3070 USA
P: 1-800-525-0758 F: 1-800-624-3925
18
SM1700
Pneumatic
Center Punch
Tool
Tool Service Information
1. If applicable, test and inspect tool to determine source of problem.
2.
Totally dismantle tool and clean all parts.
3.
Refinish external parts such as castings, cylinder, etc.
4.
Inspect all parts for wear and damage. Replace as needed*.
5.
Replace all expendable parts* such as gaskets, O-rings.
6.
Reassemble, adjust, test, and inspect.
7. Clean exterior of tool.
*Parts replaced are invoiced at current parts prices.
Factory Service is Available
Users of the SM1700 should have years of dependable production if the preventative
maintenance procedures are followed as outlined in this manual. In addition to available
service parts, BAND-IT has additional factory service available. Service charges in
addition to parts replacement charges will be invoiced if tool is not covered by our
warranty. Please visit our website for our warranty information.
www.BAND-IT-IDEX.com/Warranty.html
Factory Services
Additional Factory Support and Tool Service: