BAND-IT S75099 Pneumatic Junior Clamp Application Tool - Manual (Page 10)

Document# P36687 Rev. I
© Copyright
BAND-IT-IDEX, Inc. 2013
All rights reserved
www.BAND-IT-IDEX.com
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street Denver,
CO 80216-3070 USA
P: 1-800-525-0758 F: 1-800-624-3925
10
S75099 Pneumatic
Junior Clamp
Application Tool
1. For proper functioning of the S75099 air tool, a filter / lubricator must be used on the
air supply within 30 feet of the air tool. The warranty is voided if a filter / lubricator is
not used.
2. Before using air tool, check to see that the blade and backing plate are fully tensioned.
3. Clean gripper occasionally. Metal particles and dirt on the gripper lever can cause it to
slip off the clamp tail. To remove gripper lever, loosen set screw in the head assembly
from underneath the block and tap out pin.
Component Check Action Frequency
Clamp Head Check for loose mounting
screws Tighten all screws and fasteners Daily
Shear hook Check working edge for
wear or damage replace if necessary (J00587). Daily
Cutter Blade and
Backing Plate Check to see if blade is
loose or has any broken or
chipped edges Tighten all screws and fasteners.
Replace if necessary (J93099). Daily
Filter / Lubricator Check for build-up of dirt,
etc. Check for low,
contaminated or discolored
lubricant Drain and clean with soap and water.
Refill with hydraulic oil DTE 24. Set drip
rate to 1 drop each 10-25 cycles. Order
more lubricant if necessary (S31589). Every 2,000
clamps
Gripper Lever Check for build-up of dirt,
etc., in teeth and check
spring for tension. Remove and clean with small pointed
object - knife blade, etc. Replace as
necessary with new gripper and new
spring as a kit (S45799). Every 2,000
clamps
Cylinder Check for build-up of dirt,
contaminants externally on
piston rod seals Clean with soap and warm water 6 Months
Tripper Plate Check for cracks, build-up
of dirt, contaminants Clean and apply a light coating of moly
grease or equivalent 6 Months
Check for build-up of dirt,
contaminants, etc. Remove and clean with non-flammable
degreaser 6 Months
Check for tight connection Tension as necessary 6 Months
Air Exhaust Mufflers
Maintenance Checklist
Preventative
Maintenance