BAND-IT S35099 Automatic Air Tool - Manual (Page 21)

BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-0307 USA
P: 1-800-525-0758
F: 1-800-624-3925 Document # S41067 rev. H
© Copyright
BAND-IT-IDEX, Inc. 2010
All rights reserved
www.BAND-IT-IDEX.com
Page 21 of 34
S35099
Automatic Air Tool
PROBLEM OBSERVATION CORRECTION
13) Tool takes
excessive time
prior to actuation
of cut-off cylinder.
- Tool reaches clamp hold pressure
selected and operator must wait a
second or more before cut-off cylinder
actuates.
- Decrease the actuation time for the cut-off
cylinder (fig. 5).
- Time delay valve may be clogged. Remove
needle valve and observe. If dirty, remove valve,
disassemble and clean.
- Cut-off valve may be sticking. Remove cut-off
valve, disassemble and clean or replace (fig. 5).
14) Tool does not
read clamp hold
pressure
selected.
- Cut-off cylinder actuates before the clamp
hold pressure selected shows on the
gauge.
- Pressure drops below desired pressure
and regulates at a lower pressure.
- Pressure never regulates.
- Increase the actuation time for the cut-off
cylinder.
- Increase the clamp hold pressure.
- Adjust valve. If no response, replace hold
pressure valve.
Troubleshooting