BAND-IT S35099 Automatic Air Tool - Manual (Page 17)

BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-0307 USA
P: 1-800-525-0758
F: 1-800-624-3925 Document # S41067 rev. H
© Copyright
BAND-IT-IDEX, Inc. 2010
All rights reserved
www.BAND-IT-IDEX.com
Page 17 of 34
S35099
Automatic Air Tool
COMPONENT FREQUENCY CHECK ACTION
Cutter Blade and
Backing Plate
Daily
Check to see if blade is loose.
Look for broken or chipped
edge. Feel lower edge for
sharp edge. Tighten screws and replace
if necessary. With stone,
hone edge of cutter blade
round (figure 7).
Clamp Tail Gripper
2,000 clamps
pulled
Check for build up of foreign
material in teeth. Remove and clean with
pointed object or knife blade.
Cam Contact
Surface 2,000 clamps
pulled
Observe surface for lubricant.
Lubricate with molybdenum
disulfide grease such as
Molykote G-n.
Filter 6 months Check for accumulation of dirt.
Clean with soap and warm
water.
Lubricator
2,000 clamps
pulled
Check lubricant level. Observe
for contaminated or discolored
lubricant.
Refill to fill level with DTE 24
hydraulic oil. If needed, drain
and clean lubricator with
soap and warm water before
refilling.
Air Exhaust Mufflers
(5)
6 months Look for build up of dirt.
Remove and clean with non-
flammable degreaser such
as Gunk.
Cylinders (2) Yearly
Check for accumulation of dirt
on piston rod cylinders. Clean with soap and warm
water.
Cam Roller 6 months
Clean surface of roller and
wipe away excess lubricant.
Lubricate with SAE 30 oil.
Clamp Head 6 months
Check for loose mounting
screws.
Tighten mounting screws.
Trip Plate 6 months
Clean to remove dirt, debris,
etc. Apply Molykote G-n or
equivalent.
Maintenance
Summary