BAND-IT IT4000-AB 5/16 Band-Lok Tool - Manual (Page 4)

Document # I17794 Rev D
© Copyright
BAND-IT-IDEX, Inc. 2009
All rights reserved
www.BAND-IT-IDEX.com
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street Denver, CO 80216-0307 USA
P: 1-800-525-0758 F: 1-800-624-3925
4 of 28
IT4000-AB
5/16” Band-Lok
Tool
The IT4000 is a pneumatic tool that needs a clean and dry air supply. The BAND-IT Air
Controller Module includes a filter to meet these requirements. For proper tool
performance, the air requirements at the inlet to the BAND-IT Air Controller Module of
the IT4000 must be:
Item Min Max
Inlet Supply Pressure (PSI) 100 140
Inlet Supply Air Flow (SCFM) 1.5
Particle Size In Air Supply (microns) 5
Air Moisture Content 20% RH
Tension Pressure Settings (PSI) 50 70
Cut-off Pressure Setting (PSI) 110 115
Note
– An Air Booster Unit is now available to meet air pressure requirements.
Please have tool model and serial #’s available when calling the factory for
service assistance. Contact BAND-IT-IDEX customer service, 303-320-4555.
Caution
– Do not exceed a Tension pressure of 70 PSI. Pressures above 70 PSI
may cause premature clamp failure.
Air Controller Module
Cut-off Pressure
Regulator Tension
Pressure
Regulator
Inlet air supply
Air System