APG MPX Slave Sensor user manual - Manual (Page 44)

MPX Series Magnetostrictive Level Sensors
Rev. B, 4/13
44
Automation Products Group, Inc.
APG...Providing tailored solutions for measurement applications
Tel: 1/888/525-7300 • Fax: 1/435/753-7490 • www.apgsensors.com • [email protected]
Certificate: 2397437 Master Contract: 237484
Project: 2397437 Date Issued: May 18, 2011
DQD 507 Rev. 2009-09-01 Page: 3
manner can be used. The nameplate is affixed to the top of the enclosure. Labels, if shown in the report, may
vary slightly in layout, provided that the required information continues to be shown.
The following markings appear on each product where applicable:
• Manufacturer’s name: "Automation Products Group", or CSA Master Contract Number “237484”, adjacent to
the CSA Mark in lieu of manufacturer’s name.
• Model number: As specified in the PRODUCTS section, above.
• Electrical ratings: As specified in the PRODUCTS section, above.
• Ambient temperature rating: As specified in the PRODUCTS section, above.
• Manufacturing date in MMYY format, or serial number, traceable to month of manufacture.
• Enclosure ratings: As specified in the PRODUCTS section, above.
• The CSA Mark with or without “C” and “US” indicators, as shown on the Certificate of Conformity.
• Hazardous Location designation: As specified in the PRODUCTS section, above (may be abbreviated).
• Temperature code: As specified in the PRODUCTS section, above.
• The name or mark of the certificate issuer and the certificate reference in the following form: the last two
figures of the year of the certificate followed by the serial number of the certificate in that year.
• The following words:
• “OPEN CIRCUIT BEFORE REMOVING COVER” or "KEEP COVER TIGHT WHILE CIRCUITS ARE
ALIVE”.
• “WARNING – EXPLOSION HAZARD - Substitution of components may impair suitability for Class I,
Division 2.”
• “WARNING – EXPLOSION HAZARD – Do not connect while circuit is live unless area is known to be
nonhazardous.”
• “Install per drawing 9003468 (as appropriate for nonincendive field wiring only).”
An installation manual or data sheet shall be supplied with each unit, containing the following minimum
marking information:
General: Technical specifications, instructions for use and details of where technical assistance may be obtained
if required.
Equipment Ratings: This includes equipment supply, description of I/O connections, duty cycle and operating
environmental conditions.
• Pollution degree 2;
• Measurement category II;
• Altitude 2000 m;
• Humidity 0 to 100%;
• Electrical supply DC,
• Indoor and outdoor use statement;
• Temperature - 40°C to 85°C;
Equipment Installation: This includes instructions for assembly and mounting, location requirements, details for
special services (cooling supply, etc.) as applicable.