Anchor ANCHORSPAN AA 30FT-60FT - Manual (Page 19)

16
Do not tension the middle panel until the middle eave bars have been installed in its bay and the
adjacent middle panel has also been installed. (See Below)
Note: The eave bar will re-form the curve of the middle panel fabric to form a straight line at the
eave location. The short eave bar cradles are useful in lowering the eave bar end fittings into
their respective brackets, as shown. Tension middle panels after eave bars have been installed.
WIND
SpanLatch
Purlins
Clip rope to
fabric panel
Rope to workers
for pulling
2 to 4 workers
for pull ropes
2 workers to fed fabric
into channels
Middle panels between beams
(ready for installation)
Hook one end of eave bar into
bracket, then use eave bar cradle to
raise other end above and then into
the bracket of the next beam.
2nd beam pivoted same as
1st, but secured by SpanLatch
Purlins, rather that diagonal
brace.
Installation of Middle Panels
Installation of Mid Eave Bars