AirLive WN-200R - Manual (Page 9)

AirLive WN-200R User’s Manual 5
Chapter 2 : Installation
This Chapter covers the physical installation of the Wireless Router.
2.1 Requirements
• Network cables. Use standard 10/100BaseT network (UTP) cables with RJ45 connectors.
• TCP/IP protocol must be installed on all PCs.
• For Internet Access, an Internet Access account with an ISP, and a DSL connection.
• To use the Wireless Access Point, all Wireless devices must be compliant with the IEEE 802.11g, IEEE 802.11b
or IEEE 802.11n Draft specifications.
2.2 Procedure
Figure 4: Installation Diagram
1. Choose an Installation Site
Select a suitable place on the network to install the Wireless Router.
For best Wireless reception and performance, the Wireless
Router should be positioned in a central location with mini-
mum obstructions between the Wireless Router and the
PCs.
Also, if using multiple Access Points, adjacent Access
Points should use different Channels.
2. Connect LAN Cables
Use standard LAN cables to connect PCs to the Switching Hub ports on the Wireless Router. Both 10BaseT and
100BaseT connections can be used simultaneously.
3. Connect ADSL Cable
Connect the DSL or Cable modem to the WAN port on the Wireless Router. Use the cable supplied with your
DSL/Cable modem. If no cable was supplied, use a standard cable.
4. Power Up
Connect the supplied power adapter to the Wireless Router. Use only the power adapter provided. Using a differ-
ent one may cause hardware damage.