AirLive WL-5470POE - Manual (Page 75)

WL-5470 POE User’s Manual 72
7. Specification
Feature
54Mbps Multi-function POE AP
2 x 10/100Mbps ports, 4MB Flash, 16MB SDRAM
20dBm(EU) or 26dBm(South America) Output Power
R-SMA antenna connector
IEEE802.3af PoE standard compliance*
8 Wireless Operation Modes
Bandwidth Control and Signal Survey
Client Isolation, Watchdog, and TX Power Regulation
SSH2/HTTP/Telnet managements
DHCP Relay Agent Supported
Up to 40 Access Control List
ACK Timeout Adjustment
Watchdog, and TX Power Regulation
Hardware
2 x 10/100Mbps LAN Port, LAN1 1 with 802.3af PoE
4MB Flash, 16MB SDRAM
Reversed SMA Antenna Port
Power, LAN, WLAN LED indicators
Antenna
2 dBi detachable Dipole Antenna
Reversed SMA Connector
Frequency Range
USA (FCC) 11 Channels: 2.412GHz~2.462GHz
Europe (ETSI) 13 Channels : 2.412GHz~2.472GHz
Japan (TELEC) 14 Channels :2.412GHz~2.483GHz
Modulation Technique
11g Orthogonal Frequency Division Multiplexing (64QAM, 16QAM,
QPSK,
BPSK)
11b Direct Sequence Spread Spectrum (CCK, DQPSK, DBPSK)
Data Rate: 54, 48, 36, 24, 18,11, 5.5, 2, 1 Mbps
Output Power
18dBm
Adjustable in 4 levels
WISP Mode
DHCP, PPTP, L2TP, PPPoE ISP Authentication Support
Wireless Client function as WAN
WISP mode is not the same router mode
To configure the WISP mode, you PC must be connected to the LAN port
Security
64/128-bit WEP
WPA/WPA2-PSK support
802.1x Radius Support
WPA Enterprise support in AP/WDS mode
Configuration
Web/telnet/SSH2 Management
WDS (Bridge, Client, Repeater) mode