AirLive WL-5470POE - Manual (Page 65)

WL-5470 POE User’s Manual 62
4. System Management
4.1 LAN Interface Setup
In this page, you can change the TCP/IP settings of this Access Point; select to enable/disable the DHCP
Client, 802.1d Spanning Tree, and Clone MAC Address.
IP Address: This field can be modified only when DHCP Client is disabled. If your system manager
assigned you static IP settings, then you will have to enter the information provided.
Subnet Mask: Enter the information provided by your system manager.
Default Gateway: Enter the information provided by your system manager.
DHCP: Select Disable, Client or Server from the pull-down menu.
~ Disable: Select to disable DHCP server function.
~ Client: Select to automatically get the LAN port IP address from ISP (For ADSL/Cable
Modem).
~ Server: Select to enable DHCP server function.
DHCP Client Range: WL-5060AP IP addresses continuing from 192.168.100.1 to 192.168.100.253
Clone MAC Address: You can specify the MAC address of your Access Point to replace the factory setting.
Disable Ping: WL-5470POE did not response LAN ping if this function is checked.
Click her to
configure LAN
Interface Setup