AirLive WL-5470POE - Manual (Page 46)

WL-5470 POE User’s Manual 43
The default is 2.4GHz (B+G) mode.
¾ Site Survey: Site survey helps to find out available access point around. You can also check to prevent
using same SSID or channel with other AP.
¾ SSID (Network ID): The SSID differentiates one WLAN from another; therefore, all access points and
all devices attempting to connect to a specific WLAN must use the same SSID. It is case-sensitive and
must not exceed 32 characters. A device will not be permitted to join the BSS unless it can provide the
unique SSID. An SSID is also referred to as a network name because essentially it is a name that
identifies a wireless network.
In this mode, the SSID is provided for client connection.
¾ Channel Number: Allow user to set the channel manually or automatically. If set channel manually, just
select the channel you want to specify. If
“Auto” is selected, user can set the channel range to have
Wireless Access Point automatically survey and choose the channel with best situation for
communication. The number of channels supported depends on the region of this Access Point. All
stations communicating with the Access Point must use the same channel.
¾ Wireless Client Isolation: This is to separate wireless client if needed. Wireless clients can not
communicate to each other if the field is enabled.
¾ Site Survey: Site survey helps to find out available access point around. You can also check to prevent
using same SSID or channel with other AP.
¾ WAN Port (LAN1): WL-5470POE provides 4 methods for client to access the internet. This depends on
the location and the service which the ISP provides. You need to contact the ISP for detail information.