AirLive WL-5470POE - Manual (Page 61)

WL-5470 POE User’s Manual 58
Please follow the step below to create a new policy “VIP”
1. Enter “VIP” for the “PolicyName”
2. Enter “512” for the “LAN Out Rate”
3. Enter “1024” for the “WLAN Out Rate”
4. Enter “VIP Subscriber” for the “Comment”
5. Click on “Save” button
6. Now the “VIP” policy will show up in the “Current Policy Table”
Once finished, the administrator will be able to choose the policy “VIP” for their IP/MAC Traffic Control.
C.
Bandwidth Control by IP address
You can set the maximum bandwidth of a PC or a subscriber by using the IP Control.
Please follow the procedure below to setup IP Traffic Control
1.
Please make sure the “Interface Traffic Control” is disabled
2. Before you start, please check the following area to see which client IPs are supported. It differs
between each mode.
3.
Enable the IP Control
4. If you have defined a Policy already, please choose a Policy name. The “Out Rates” will be
automatically pasted from the Policy template. You cannot change the Out Rates if you have chosen a
Policy
5. If you want to define new Data Rate, please do not choose any policies. Then you can enter the values
in the “LAN”, “WLAN”, or “WAN” Out Rates.
6. Press “Save” to save settings
7. Reboot your AP.
* If you want to control the traffic flow between the IPs in the same interface, please make sure both IPs are
configured for the IP Traffic Control.
D.
Bandwidth Control by MAC address
You can set the maximum bandwidth of a PC or a subscriber by using the MAC Control.
Please follow the procedure below to setup MAC Traffic Control
1.
Please make sure the “Interface Traffic Control” is disabled
2. Before you start, please check the following area to see which client MACs are supported. It differs
between each mode.
3. Enable the MAC Control
Please check this part to find out what IP addresses
are supported. It varies between each mode
Please check this part to find out what IP addresses
are supported. It varies between each mode