beautypg.com

Mode switching with 1-button models – 2N Helios IP Vario User Manual

Page 38

background image

38

2N TELEKOMUNIKACE a.s., www.2n.cz

®

2N

®

Helios IP Vario gets the IP address upon restart only if the DHCP server is

configured properly.

Mode Switching with 1-Button Models

In case your

device is equipped with 1 button, you can switch

2N

®

Helios IP Vario

the modes using one button only.

Connect

to the power supply (or, disconnect and reconnect

2N

®

Helios IP Vario

it if already connected).
Wait for the first acoustic signal

.

Press button 1 15 times.

The acoustic signal

indicates mode switching.

Wait until the device is restarted automatically.

Figure 3.3 Switching between static and dynamic IP address

The static IP address mode will be switched into the dynamic IP address mode and vice
versa upon restart.

Note

The 2, 1, 1, 2, 2, 3 sequence must be entered within 30 seconds after the
first sound signal for security reasons. The inter-digit delay may be 2s at
most.

Note

The 15 times 1 sequence must be entered within 30 seconds after the first
sound signal for security reasons. The inter-digit delay may be 2s at most.