beautypg.com

2N Helios IP Vario User Manual

Page 18

background image

18

2N TELEKOMUNIKACE a.s., www.2n.cz

®

Figure 2.2 Cover Removing

Figure 2.3 Plastic Cover Removing

Figure 2.4 Multiple-Module Assembly

4. In multiple-module assemblies connect the boxes according to Figure 2.4, placing
the basic module to the left and the extending modules to the right. The
interconnecting cable shall be connected later!

5. Install blank modules on the unused side holes as shown in Figure 2.4.

6. If you are installing a roof module, put it on the wall now.

7. Fix

on the wall with screws as shown in Figure 2.6. Carry the

2N

®

Helios IP Vario

supply cables (Ethernet, lock, power cables) to the basic module box through one of
the holes.

Warning

Never remove the main board or camera electronics from under the lower
cover while installing

. Do not disconnect the

2N

®

Helios IP Vario

camera flat cable from the main board. Do not bend and press upon the
flat cable either.