2N Helios IP Vario - Manual (Page 27)

27
2N TELEKOMUNIKACE a.s., www.2n.cz
®
1.
2.
3.
4.
5.
6.
Resetting procedure
Switch off. 2N
®
Helios IP Vario
Connect the jumper into the resetting (default setting) position (put the display
switch into the F_RES position in the display-equipped models with 535v1 and
535v2 board versions).
Switch
on and wait for the acoustic start signalling. 2N
®
Helios IP Vario
Switch off. 2N
®
Helios IP Vario
Remove the jumper from the resetting (default setting) position (put the display
switch into the NORMAL position in the display-equipped models with 535v1 and
535v2 board versions).
Switch
on. 2N
®
Helios IP Vario
Table 2.5 Configuration Jumpers on Display Connector
Figure 2.14 Resetting Procedure – Display Model
To reset the default values of a display-equipped , put the switch 2N
®
Helios IP Vario
in the display right-hand bottom corner in position F_RES. This applies to modules with
board versions 535v1 and 535v2 only. For 535v5 versions, use a jumper at connector
X19.