beautypg.com

Video, Configuration 3.3, Microphone settings – 2N Helios IP User manual, 1510 v1.11 User Manual

Page 74

background image

Configuration

3.3

74

Warning volume

Set the volume of the 2N

®

Helios IP signal tones that announce status changes.

Key beep volume

Set the volume of the tone generated whenever a key is pushed.

Lock open volume

Set the volume of the unlocking signalling tone.

Call tones

Set the volume of the dialling, ringing and busy tones if generated by 2N

®

Helios IP.

Ringing

Set the volume of the incoming call signalling tone – ringing tone. Incoming calls
are signalled when the automatic incoming call receiving function is off, see the
Miscellaneous subsection.

Microphone Settings

Sensitivity

Set the microphone sensitivity.

AGC (Automatic Gain Control)

Set whether the Automatic Gain Control function should be used.

Noise reduction

Set the mode for noise reduction arising primarily during echo cancellation.

Video

This menu is used to set the video camera. To set the codec properties use the
Advanced Settings –> Video codecs menu, see the Video Codecs subsection.

Brightness

Set the intensity of the video camera stream.

Colour saturation

Set the colour saturation of the video camera stream.

Flip horizontally

Set whether the picture is to be flipped horizontally.

Frame rate decreasing

Enable an automatic decreasing of the frame rate under poor light conditions,
which improves the video quality to the detriment of the frame rate.

Flicker avoidance

Here you can eliminate flicker caused by artificial sources of light such as fluorescent
lamps. The flicker frequency depends on the light source power supply frequency.