2N Analogue GSM gateway 2N EasyGate - Manual, 1575 v1.1.0.2 - Manual (Page 40)

Table of Parameters 3.2
40
COM enable Function No.: 50
With this parameter you can enable/disable the serial interface function. You can
disable communication in the operating mode, maintaining the special
programming mode after power up.
Setting options: YES/NO
Default setting: YES
Time period for GGMC SMS [h] Function No.: -
Time interval for GGMC SMS sending. GGMC = GSM Gateway Monitoring Centre.
The "0" setting means that the function is disabled.
Setting options: 0-255 h
Step: 1 h
Default setting: 0
Telephone number for service SMS Function No.: -
Telephone number for service SMS. The number is common for GGMC SMS and
"LOW CREDIT" SMS on prepaid SIM cards.
Setting options: 0-16 characters (0-9,*,#,+)
Default setting: blank
Initialization
All programmable parameters are arranged in tables according to their functions. You
can initialize either all parameters at once or one table of parameters.
For initialization via a telephone line fill in the function number according to the type
of initialization and enter the service password as the parameter.
Telephone line initialization Function No.: 91
Initialization of all parameters necessary for the telephone line function.
Call table initialization Function No.: 92
Initialization of all parameters related to dialed telephone number.
Initialization of GSM & SIM Function No.: 94
Initialization of all parameters related to the GSM network and SIM card (except
for the PIN code).
SMS input initialization Function No.: 93
Initialization of all parameters for SMS sending upon SMS input activation.