2 table of parameters, Telephone line parameters – 2N Analogue GSM gateway 2N EasyGate - Manual, 1575 v1.1.0.2 User Manual
Page 29
Table of Parameters
3.2
29
3.2 Table
of
Parameters
All programmable parameters are listed in this section. Each parameter is
accompanied with the unit used, function number (if available) for programming via a
telephone line, description of EasyGate's behavior, setting options, setting step and
default (initialization) value.
Telephone Line Parameters
Dialing parameters
Type
of
dialing
Function
No.:
-
Select the dialing type to be received by EasyGate from the PBX or telephone set.
EasyGate accepts only the selected type of dialing, ignoring the others.
Setting options:
DTMF -EasyGate receives tone dialing only.
Pulse
-EasyGate receives pulse dialing only
Default setting:
DTMF
Time
to
dial
[s]
Function
No.:
-
Timeout during which EasyGate waits for further digits to be dialed. It starts to
establish connection when this timeout passes.
Setting options:
1-15 s
Setting step:
1 s
Default setting:
5 s
Minimal
On
Hook
[ms]
Function
No.:
-
The minimum line current discontinuation that EasyGate evaluates as hang-up.
Setting options:
100-1500 ms
Setting step:
100 ms
Default setting:
500 ms
Beep after dialing end
Function No.: -
Select a beep to signal the end of dialing (beginning of outgoing call establishing).
Setting options:
YES/NO
Default setting:
YES