2N Analogue GSM gateway 2N EasyGate - Manual, 1575 v1.1.0.2 - Manual (Page 25)

2N® EasyGate parameters configuration 3.1
25
To cancel any programming step in the programming mode, press a . Having done
so, you can hear the refusal tone and can enter a new parameter number. Parameters
are saved when the saving tone is transmitted. Hang up to quit programming.
Example:
Dial Confirmation Description
Password entering, OK
Transmission volume parameter, OK
Set to medium level, saved
Non‐existent parameter number, refusal
PC based Programming
For programming, connect EasyGate to a PC with a serial cable and make sure that
the EasyGate PCManager is installed. Programming is intuitive and easy. All steps are
accompanied with texts hints above all items you point at with the mouse.
EasyGate data uploading and storing, including firmware upgrade, are executed in a
special mode, in which EasyGate waits for about 3s after power up (all LEDs are on).
If instructed so by the PCManager during this timeout, EasyGate remains in this mode
as long as it is necessary. If EasyGate is not reset after the PCManager is terminated,
switch the system off and on again.
Language
selection
Data handling
Programming
tables
Monitoring
Figure 3.1
EasyGate
PC Manager
basic screen