2N Analogue GSM gateway 2N EasyGate - Manual, 1575 v1.1.0.2 - Manual (Page 34)

Table of Parameters 3.2
34
Every table line includes a prefix (of variable length) plus parameters that define
EasyGate's behavior in case the beginning of the dialed number matches this prefix.
The table can contain up to 20 different prefixes.
There may be exceptions to the rule - a number may start with the same digits but
has to be served in a different way. Any table line that starts with the same prefix
followed by one or more digits is considered an exception of the line with shorter
prefix.
Remember to complete the "Other numbers" line for a number whose prefix is not
included in the table.
An example in the figure below shows how to bar all international calls with the
exception of calls to Slovakia including dialing acceleration by selecting the number
length parameter and tariff setting (5 impulses after call connect and then one
impulse every 10 seconds). All other calls are enabled and their tariff is one impulse
every 30 second.
Operator for Integra Function No.: -
In some GSM networks you can add to dialed number # character and PBX
subscriber number. Subscriber number is displayed on other side together with
CLI. This parameter take place when dialed number doesn't contain # character.
Setting options: 0-8 characters (0-9)
Default setting: blank
Routing table enable Function No.: 20
Enable the use of the routing table with this parameter. Disabling this parameter
you put the table out of use.
Setting options: YES/NO
Default setting: NO
Figure 3.2
Routing table