Brother MFC 8700 - Manual (Page 49)

I N I T I A L S E T U P 4 - 5
Setting Volume Amplify
Please carefully read “Choosing the Handset Volume,” page 4-4 before
you do the following steps:
1 For the FAX, press Function , 1 , 7 .
For the MFC, press Function , 1 , 1 , 7 .
2 If none of the users are V O L A M P L I F Y : O N ?
S E L E C T <- -> & S E T
hearing-impaired, press or
to select VOL AMPLIFY:OFF?
and press
Set , then go to Step 4
—OR—
If some or all of the users
are hearing-impaired, select
VOL AMPLIFY:ON? and press
Set .
3 If all the users are hearing-impaired,
P E R M A N E N T ?
S E L E C T <- -> & S E T press or to select PERMANENT?
and press Set
—OR—
If only some of the
T E M P O R A R Y ?
S E L E C T <- -> & S E T users are hearing-impaired, select
TEMPORARY? and press
Set .
4 Press Stop to exit.
Setting the Speaker Volume
You can adjust the speaker volume when your machine is on Hook .
Press Volume or to adjust the volume level. The display shows the
setting you are choosing. Each key press changes the volume to the next
setting. The new setting will remain until you change it again.
Setting the Ring Volume
You can adjust the ring volume when your machine is idle. You can turn
the ring OFF or you can select a ring volume level.
Press Volume or to adjust the volume level. With each key press, the
machine rings as you hear the current setting and the display shows the
setting you are choosing. Each key press changes the volume to the next
setting. The new setting will remain until you change it again.
Memory Storage
In the event of a power failure, all settings in the INITIAL SETUP,
SETUP RECEIVE, SET AUTO DIAL and REMOTE FAX OPTIONS, plus
the COVERPG SETUP and COVERPG MSG (from SETUP SEND)
functions are stored permanently. You may have to reset the date and time.