JLG DVSP Series Service Manual - Manual (Page 69)

SECTION 4 - CONTROL COMPONENTS
3121136 – JLG Lift – 4-11
Entering Password
Programming Mode Selection
Selecting Programmable Item to Adjust
Adjusting Programmable Setting
TO EXIT Programming Mode after entering programma-
ble settings, power machine off with either the Main
Power Selector Switch or Emergency Stop Button.
Entering Password
1. The Brake Release button (1) moves the box (around
digit) from left to right to select which digit to change.
2. Platform UP button (2) increases the numerical digit.
3. Platform DOWN button (3) decreases the numerical
digit.
4. Change all five digits (4) to match password level,
then press the Brake Release button (1) again.
Programming Mode Selection
1. Use Platform UP/DOWN buttons (1) to move the
selection box (2) up or down to select item to pro-
gram.
2. Press the Brake Release button (3) to enter selected
mode then move on to Selecting Programmable Item
to Adjust.
1 2 3
00000
4
1
2
3
Selecting Programmable Item to Adjust
1. Use the Platform UP/DOWN buttons (1) to scroll
through the list of programmable items available to
your programming level.
2. Once a programmable item to be adjusted is selected,
press the Brake Release button (2) to enter that set-
tings’ adjustment mode.
Adjusting Programmable Setting
1. Adjust the programmable setting using the Platform
UP/DOWN buttons (1), see Table 4-1 for range of set-
tings for the item selected.
2. Once parameter is set for the programmable item,
press the Brake Release button (2), this will enter the
parameter and return you to the Programmable Set-
tings Menu.
1 2
1 2